II106700-7
Rev. -
Page 51
Figure 29a. Remove the drag link from the pitman arm on the steering box.
b. Disconnect the drag link (3) from the pitman arm (8).
1. Use the drill template (P/N 107406-1) to locate the through-hole locations on the
driver's-side fender support behind the cab (see Figure 30).
2. Mark and center-punch the hole locations and drill four pilot holes through the
bottom surface of the driver's-side fender support using a right-angle drill and a
1/4-in. drill bit (See Figure 30a).
Figure 30. Drill Template (P/N 107406-1).