TM9-2320-363-34-2
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
M915A2 AND M916A1
ALL EXCEPT M915A2 AND M916A2
LEFT SIDE-FRONT
POSITION CYLINDER BLOCK TO VIEW LEFT SIDE.
COAT OUTSIDE SEALING EDGE OF l-IN. CUP PLUG (9) WITH NON-HARDENING SEALANT. USING
SMALL END OF DOUBLE-ENDED PLUG INSTALLER (5) AND HANDLE (3) INSTALL CUP PLUG (9)
0.098-0.118-IN. (2.5-3.0 mm) BELOW MACHINED SURFACE OF FRONT OF CYLINDER BLOCK.
INSTALL TWO 3/8-IN. PIPE PLUGS (10) (M915A2 AND M916A1) OR THREE PLUGS (10) (ALL
EXCEPT M915A2 AND M916A1).
NOTE
Cylinder block repair conditions may warrant cylinder block pressure testing before complete
block assembly. Perform testing after installing cylinder liners, cup plugs, and pipe plugs. (Refer
to Cylinder Block Pressure Testing, page 12-88).
INSTALL AIR COMPRESSOR OIL SUPPLY LINE ELBOW (11).
INSTALL AIR COMPRESSOR COOLANT SUPPLY ELBOW (12).
NOTE
If cylinder block is not being placed in service, perform steps 11 thru 15.
INSTALL 1/4-IN. PIPE PLUGS IN TAPPED HOLES FOR OIL PRESSURE SENSOR (13) AND OIL
TEMPERATURE SENSOR (14).
INSTALL 1/4-IN. PIPE PLUG IN PLACE OF AIR COMPRESSOR OIL SUPPLY LINE ELBOW (11).
INSTALL 1/2-IN. PIPE PLUG IN PLACE OF AIR COMPRESSOR COOLANT SUPPLY ELBOW (12).
INSTALL SIX WEEP HOLE PLUGS (15).
SPRAY OR DIP CYLINDER BLOCK IN POLAR-TYPE RUST PREVENTIVE FOR EXTENDED
STORAGE.
Change 1
12-85