7.
8.
9.
TM9-2320-363-34-2
NOTE
Camshaft is mounted in cylinder head; therefore, resurfacing of block and/or head
affects position of camshaft in relation to adjustable idler gear and gear train.
Limit resurfacing on cylinder block to maximum of 0.01 in. (0.25 mm). Limit
resurfacing on block and head to combined total of 0.03 in. (0.75 mm). If limits
are exceeded, replace cylinder block.
CHECK FRONT-TO-REAR FLATNESS, NEXT TO CYLINDER LINER FLANGES ON BOTH SIDES,
AND SIDE-TO-SIDE FLATNESS BETWEEN LINER FLANGES, AS SHOWN. DECK MUST BE FLAT
WITHIN 0.005 IN. (0.120 mm) FRONT-TO-REAR AND 0.003 IN. (0.076 mm) SIDE-TO-SIDE. IF NOT,
RESURFACE CYLINDER BLOCK.
SPRAY MACHINED SURFACES WITH ENGINE LUBRICATING OIL IF CYLINDER BLOCK IS NOT TO
BE USED IMMEDIATELY. SPRAY OR DIP CYLINDER BLOCK IN POLAR-TYPE RUST PREVENTIVE
FOR EXTENDED STORAGE.
MEASURE CYLINDER LINER COUNTERBORE DIAMETER (A) AND DEPTH (B). DIAMETER
SHOULD BE 6.186-6.191 IN. (157.15-157.25 mm). DEPTH SHOULD BE 0.3514-0.3533 IN.
(8.9246-8.9746 mm).
12-83
