TM9-2320-363-34-2
CYLINDER BLOCK ASSEMBLY REPAIR (CONT)
1.
2.
3.
4.
5.
M915A2 AND M916A1
ALL EXCEPT M915A2 AND M916A1
RIGHT SIDE - REAR
COAT OUTSIDE SEALING EDGE OF FIVE 1-1/2-IN. DIAMETER CUP PLUGS (1) WITH NON-
HARDENING SEALANT. USING SINGLE-SIDE PLUG INSTALLER (2) AND HANDLE (3), INSTALL FIVE
CUP PLUGS (1) TO 0.098-0.118-IN. (2.5-3.0 mm) BELOW MACHINED SURFACES ON RIGHT SIDE
OF CYLINDER BLOCK.
COAT OUTSIDE SEALING EDGE OF I-IN. CUP PLUG (4) WITH NON-HARDENING SEALANT. USING
SMALL END OF DOUBLE-ENDED PLUG INSTALLER (5) AND DRIVER HANDLE (3), INSTALL CUP
PLUG (4) 0.098-0.118 lN.(2.5-3.0 mm) BELOW MACHINED SURFACE OF REAR OF CYLINDER
BLOCK.
INSTALL TWO 3/8-IN. PIPE PLUGS (6) (M915A2 AND M916A1) OR PIPE PLUG (6) AND PIPE PLUG
(6.1) (ALL EXCEPT M915A2 AND M916A1).
INSTALL FOUR 1/4-IN. PIPE PLUGS (7) (M915A2 AND M916A1) OR FIVE PIPE PLUGS (7) ( ALL
EXCEPT M915A2 AND M916A1).
INSTALL DRAINCOCK (8) (M915A2 AND M916A1) OR STUD (8.1) (ALL EXCEPT M915A2 AND
M916A1).
12-84
Change 1
