TM 9-2320-363-34-2
STEERING GEAR REPAIR (CONT)
C L E A N I N G
Use general cleaning methods to clean all parts (page 2-30).
I N S P E C T I O N
1.
INSPECT ALL PARTS FOR WEAR OR DAMAGE.
2.
USING CALIPERS, MEASURE INSIDE DIAMETER (A) OF SIDE COVER AND OUTSIDE DIAMETER
(B) OF SECTOR SHAFT. SUBTRACT MEASUREMENT B FROM A. IF RESULT EXCEEDS 0.008 IN.
(0.20 mm), REPLACE SIDE COVER.
1.
INSTALL RETAINING RING (1) IN INSIDE RING GROOVE OF HOUSING (2).
2.
USING INSTALLATION END OF TRUNNION INSTALLER AND DRIVE HANDLE (3), INSTALL NEW
ROLLER BEARING (4).
19-18
