TM 9-2320-363-34-2
12.
13.
14.
15.
USING SPANNER WRENCH (22), INSTALL ADJUSTER (21) IN VALVE HOUSING (9). TIGHTEN
ADJUSTER (21) TO 11-15 LB-FT (14.9-20.3 N.m) TO SEAT COMPONENTS, THEN BACK OFF 1/4
TO 1/2 TURN.
.
REVERSE VALVE HOUSING (9) IN VISE.
USING 19 mm 12-POINT DEEP SOCKET (23), ROTATE INPUT SHAFT (16).
TORQUE REQUIRED TO ROTATE INPUT SHAFT IN EACH DIRECTION.
USING SPANNER WRENCH (22), TIGHTEN ADJUSTER (21) SO THAT TORQUE
SHAFT (16) IS 5-10 LB-IN. (0.56-1.13 N.m) HIGHER THAN NOTED IN STEP 14 ABOVE. MAXIMUM
NOTE AMOUNT OF
READING ON INPUT
TORQUE REQUIRED TO ROTATE INPUT SHAFT MUST NOT EXCEED 22 LB-IN. (2.5 N.m).
19-21
