TM 9-2320-363-34-2
106.
107.
108.
109.
ROTATE INPUT SHAFT (28) AND PUSH YOKE (42) TOWARD DIFFERENTIAL CARRIER (3) TO
MAKE SURE INPUT SHAFT (28) IS AT BOTTOM OF TRAVEL.
INSTALL DIAL INDICATOR WITH POINT ON END OF INPUT SHAFT (28). ZERO DIAL INDICATOR.
USING PRY BAR, PRY UP ON FLANGE OF YOKE (42) AND READ DIAL INDICATOR.
ACCEPTABLE READING IS 0.002-0.008 IN. (0.05-0.2 mm).
IF INPUT BEARING END PLAY IS NOT WITHIN SPECIFICATION, ADD OR REMOVE SHIM(S)
FROM SHIM PACK (58). REPEAT STEPS 98 THRU 103.
110.
INSTALL COVER (62), FIVE WASHERS (63), AND FIVE CAPSCREWS (64). TIGHTEN CAPSCREWS
TO 45-55 LB-FT (60-75 N.m).
17-45
