TM 9-2320-363-34-2
REAR COVER AND FIRST CLUTCH REPLACEMENT AND REPAIR (CONT)
14.
15.
16.
17.
INSTALL 30 PISTON RELEASE SPRINGS (13) IN FIRST CLUTCH PISTON (3).
INSTALL PISTON SPRING RETAINER (14) ON PISTON RELEASE SPRINGS (13).
USING CLUTCH SPRING COMPRESSOR (15), PUSH DOWN ON PISTON SPRING RETAINER (14)
AND PISTON RELEASE SPRINGS (13) UNTIL RETAINING RING GROOVE IN REAR COVER (8) IS
CLEARED.
INSTALL RETAINING RING (16). REMOVE CLUTCH SPRING COMPRESSOR (15).
Orifice plug must clear chamfer
shaft.
18. IF REMOVED, INSTALL NEW ORIFICE
19. COAT OUTPUT SHAFT BUSHING (19)
NOTE
at front of plug bore when installed in output
PLUG (17) IN OUTPUT SHAFT (18).
WITH RETAINING COMPOUND.
20. INSTALL OUTPUT SHAFT BUSHING (19) IN OUTPUT SHAFT (18) USING OUTPUT SHAFT
BUSHING INSTALLER (20).
14-142
