TM 9-2320-363-34-2
5.
LIGHTLY COAT ONE SIDE OF NEW GASKET (5) WITH GAA.
6.
SET GASKET (5) ON TRANSMISSION (3) WITH GREASED SIDE OF GASKET DOWN.
7.
ALINE HOLES IN GASKET (5) WITH HOLES IN TRANSMISSION (3).
8.
INSTALL SLING LlFTING DEVICE ON REAR COVER (6).
NOTE
There are two different size dowel pins on screw flange face of rear cover to
help aline cover with transmission.
9.
ALINE DOWEL HOLES AND INSTALL REAR COVER (6) ON TRANSMISSION (3).
10. REMOVE LIFTING DEVICE.
11. INSTALL 21 SCREWS (7) AND 21 LOCK WASHERS (8).
12. INSTALL THREE SCREWS (9) AND THREE LOCK WASHERS (10).
13. TIGHTEN SCREWS (7 AND 9) ALTERNATELY TO 70-80 LB-FT (95-108 N.m).
14. REMOVE NUT (11) AND YOKE (12).
NOTE
Follow-on Maintenance:
Install governor (page 3-260).
Install transmission output yoke (page 3-256).
14-145
