TM 9-2320-363-34-2
3.
MEASURE INSIDE DIAMETER OF BUSHING (1),
4.
CHECK CLEARANCE BETWEEN DIAMETER OF MAIN SHAFT BEARING SURFACE, MEASURED ON
PAGE 14-123, AND BUSHING DIAMETER MEASURED IN STEP 3. IF CLEARANCE IS GREATER
THAN 0.004 IN. (0.10 mm), REPLACE BUSHING (1).
R E P A I R
Use general repair methods to repair damaged parts (page 2-33).
1.
2.
STACK 13 CLUTCH PLATES (1 AND 2) ON FLAT SURFACE OF PRESS STARTING WITH STEEL
PLATE (1) AND ALTERNATING WITH FRICTION PLATE (2).
PLACE FIRST CLUTCH PISTON (3) ON TOP OF 13 CLUTCH PLATES (1 AND 2).
14-139
