TM 9-2320-363-34-2
THIRD CLUTCH AND HOUSING REPLACEMENT AND REPAIR (CONT)
5.
INSTALL SLEEVE SPACER (9) ON HUB OF CENTER SUPPORT HOUSING (2) AND PLACE
CENTER SUPPORT PRESSURE PLATE (10) ACROSS TRANSMISSION HOUSING (4) WITH TWO
SCREWS (11).
6.
TIGHTEN CENTER SUPPORT PRESSURE PLATE (10) CENTER SCREW TO 5 LB-FT (7 N.m) TO
COMPRESS CENTER SUPPORT HOUSING (2).
7.
PLACE RETAINING RING GAUGE (12) IN RETAINING RING OPENING (13). MEASURE RETAINING
RING OPENING (13) WITH EACH OF FOUR COLORED LUGS ON GAUGE (12) TO DETERMINE
LUG WITH TIGHTEST FIT.
BLUE COLOR CODED RETAINING RING IS 0.148-0.150 IN. (3.76-3.81 mm) THICK.
YELLOW COLOR CODED RETAINING RING IS 0.152-0.154 IN. (3.86-3.91 mm) THICK.
WHITE COLOR CODED RETAINING RING IS 0.155-0.157 IN. (3.94-3.99 mm) THICK.
RED COLOR CODED RETAINING RING IS 0.158-0.160 IN. (4.01-4.06 mm) THICK.
8.
INSTALL RETAINING RING (14) THAT HAS SAME COLOR CODE AS LUG OF GAUGE (12).
RETAINING RING GAP MUST BE OPPOSITE OIL PAN SIDE (15) OF TRANSMISSION HOUSING (4).
9.
REMOVE CENTER SUPPORT PRESSURE PLATE (10) AND SLEEVE SPACER (9).
14-114
