TM 9-2320-363-34-2
THIRD CLUTCH AND HOUSING REPLACEMENT AND REPAIR (CONT)
3.
USE CENTER SUPPORT (3) TO SWAGE BUSHING (2) BY STAKING EDGES OF OIL HOLE (4).
4.
SET THIRD CLUTCH PISTON (5) IN FRONT CAVITY OF CENTER SUPPORT HOUSING (1).
5.
INSTALL 20 PISTON RELEASE SPRINGS (6) IN POCKETS ON THIRD CLUTCH PISTON (5).
NOTE
Tabs on clutch ring are different sizes and must match slots in third clutch piston
for installation.
6.
INSTALL CLUTCH RING (7) ON THIRD CLUTCH PISTON (5).
I
C A U T I O N
Clutch ring must be pushed completely down in center support housing while
installing retaining rings or clutch clearance will be wrong and transmission
will not shift properly.
7.
INSTALL FOUR NEW RETAINING RINGS (8) AND REMOVE THIRD CLUTCH PISTON (5) FROM
CENTER SUPPORT HOUSING (1).
14-110
