TM 9-2320-363-34-2
PISTON AND CYLINDER ASSEMBLY REPLACEMENT (CONT)
CAUTION
If liners are not to be installed at this time, oil them lightly with clean
engine lubricating oil and store them upright in clean, dry area to prevent
damage to equipment.
Do not allow liners to rest on sides. Do not store anything on top of liners.
To do so could result in damage to equipment.
NOTE
Do not hone used liners. Series 60 cylinder liners are honed at the factory with
process that cannot be duplicated in the field.
When installing used liners in proper bores of cylinder block, measure inside
diameter at points shown in liner diagram. Maximum diameter of used liner is
5.122 in. (130.100 mm) at any measurement location. Check liner taper and
out-of-round. Inside diameter of new service liner is 5.118-5.120 in.
(130.00-130.05 mm).
If any measured cylinder liner specifications are out of limits, liner must be
discarded.
15. COAT BORE OF LINER WITH CLEAN ENGINE LUBRICATING OIL AND ALLOW LINER TO SIT FOR
10 MINUTES TO ALLOW OIL TO WORK INTO SURFACE FINISH.
OF LINER WITH
CLEAN, WHITE PAPER TOWELS. IF DARK RESIDUE APPEARS
REPEAT OILING
AND WIPING UNTIL RESIDUE NO LONGER APPEARS.
WIPE INSIDE
ON TOWELS,
12-154
