TM 9-2320-363-34-2
PISTON AND CYLINDER ASSEMBLY REPLACEMENT (CONT)
6.
7.
8.
9.
10.
When correctly positioned, side
oil cooler side of cylinder block
with cylinder head bolt holes.
NOTE
of cylinder liner installer stamped COOLER is on
and cylinder liner installer holding bolts will aline
CENTER AND INSTALL CYLINDER LINER INSTALLER (5) OVER CYLINDER LINER (1) AND
TIGHTEN THREE BOLTS (6).
TURN CENTER BOLT (7) OF CYLINDER LINER INSTALLER (5) UNTIL CYLINDER LINER (1)
BOTTOMS IN COUNTERBORE.
USING DIAL INDICATOR (9), MEASURE CYLINDER LINER (1) PROTRUSION IN THREE EQUAL
POSITIONS. MEASURE DISTANCE FROM TOP OF CYLINDER LINER (1) FLANGE TO TOP OF
CYLINDER BLOCK (10). ALLOWABLE CYLINDER LINER (1) PROTRUSION IS 0.000-0.003 IN.
(0.000-0.076 mm) WITH NO MORE THAN 0.002 IN. (0.05 mm) VARIATION BETWEEN ANY TWO
ADJACENT CYLINDERS.
REPEAT STEPS 1 THRU 8 FOR REMAINING CYLINDER LINERS (1) BEING INSTALLED,
PERFORM CYLINDER BLOCK PRESSURE TESTING (PAGE 12-88).
12-156