TM 9-2320-363-34-2
1.
2.
3.
4.
5.
C A U T I O N
Make sure cylinder block is rotated so that cylinder block deck is up and
level. Failure to do so could result in damage to seal rings and crevice seal.
NOTE
Make sure block counterbores and cylinder liner flange are free of foreign
material or damage.
CLEAN INSIDE AND OUTSIDE OF NEW CYLINDER LINER (1) AND CYLINDER BLOCK BORE (2).
INSTALL NEW CREVICE SEAL (3) AND TWO NEW SEAL RINGS (4) ON CYLINDER LINER (1).
COAT TWO SEAL RINGS (4) AND CREVICE SEAL (3) WITH THIN FILM OF LUBRICATING OIL.
COAT CYLINDER BLOCK LINER BORE (2) WITH LUBRICATING OIL WHERE SEAL RINGS (4) AND
CREVICE SEAL (3) SEAT.
INSTALL CYLINDER LINER (1) IN CYLINDER BLOCK BORE (2) BY HAND UNTIL LOWER SEAL
MEETS UPPER CREVICE SEAL BORE.
12-155
