TM 9-2320-363-34-1
NOTE
Steps 1 thru 3 are the same for all vehicles.
1.
USING SUITABLE JACK STANDS, SUPPORT INPUT YOKE (1) OF FORWARD-REAR AXLE (2) AND
INPUT YOKE (3) OF REAR AXLE (4).
NOTE
Tag spacer washers prior to removal to aid in installation.
2.
REMOVE TWO NUTS (5). TWO WASHERS (6), TWO SCREWS (7), TWO WASHERS (8), AND TWO
SPACER WASHERS (9) FROM FORWARD-REAR AXLE (2).
3.
REPEAT STEP 2 TO DISCONNECT TORQUE ROD FROM REAR AXLE (4).
NOTE
Perform step 4 for M915A2. Perform step 5 for all except M915A2.
4.
REMOVE TWO NUTS (10), TWO WASHERS (11), TWO SCREWS (12), TWO WASHERS (13), TWO
TORQUE RODS (14), AND TWO MOUNTING BRACKETS (15) FROM FRAME (16).
5.
REMOVE THREE NUTS (17), THREE WASHERS (18), THREE SCREWS (19), THREE WASHERS
(20), TWO TORQUE RODS (21), AND TWO MOUNTING BRACKETS (22) FROM FRAME (23).
Use general cleaning methods to clean all parts (page 2-30).
Inspect all pans for wear or damage.
Change 1
9-15
