TM 9-2320-363-34-1
2.
INSTALL NEW SEAL ASSEMBLY (3) ON CHAMFERED SIDE OF THRUST BEARING (4).
3.
INSTALL STEERING KNUCKLE (2).
4.
INSTALL THRUST BEARING (4) AND SEAL ASSEMBLY (3).
5.
USING SUITABLE JACK, RAISE STEERING KNUCKLE (2) UNTIL SEAL ASSEMBLY (3) IS FLUSH
WITH BOTTOM SIDE OF AXLE (5).
6.
USING FEELER GAGE, MEASURE DISTANCE BETWEEN TOP SIDE OF AXLE (5) AND STEERING
KNUCKLE (2).
W A R N I N G
Shims are delicate and sharp. Use extreme caution when alining shims to
prevent cutting fingers or bending inside diameter of shims. Damage to shims
will require complete disassembly and replacement of damaged parts.
7.
INSTALL NEW SHIM(S) (6) OF THICKNESS EQUAL TO MEASUREMENT FROM STEP 6.
5-48
