TM 9-2320-363-34-1C A U T I O NMake sure shim(s) is not blocking passage for pin installation to preventdamage to equipment.NOTEMake sure draw key slots aline with draw key holes.If pin will not pass completely thru steering knuckle, but passed thru shim(s),lower jack to aline thrust bearing and seal assembly to allow passage of pin.8.INSTALL PIN (7) IN STEERING KNUCKLE (2).9.INSTALL TWO DRAW KEYS (8) AND TWO NUTS (9). TIGHTEN NUTS TO 30-40-LB-FT (41-54 N.m).10. POSITION STEERING KNUCKLE (2) IN STRAIGHT-AHEAD POSITION AND INSTALL DIALINDICATOR ON STEERING KNUCKLE (2) AS SHOWN.5-49
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
