TM 9-2320-363-34-1
3.
4.
5.
6.
7.
C A U T I O N
Do not interchange oil pressure regulator valve and oil pressure relief valve
to prevent damage to equipment, Oil pressure regulator valve port opening is
larger than oil pressure relief valve port opening. Oil pressure regulator valve
is also identified by pin located farthest from outlet port.
NOTE
Make sure all old gasket material has been removed from mating surfaces of oil
pressure relief valve and elbow.
INSTALL NEW GASKET (7) AND OIL PRESSURE RELIEF VALVE (8) ON OIL OUTLET TUBE
ELBOW (9). INSTALL TWO BOLTS (10) AND TIGHTEN TO 22-24LB-FT (30-38 N.m).
COAT TWO NEW SEAL RINGS (11 AND 12) WITH LIGHT ENGINE LUBRICATING OIL. INSTALL
SMALLER SEAL RING ON ELBOW END OF OIL OUTLET TUBE (13) AND LARGER SEAL RING ON
PUMP END OF OIL OUTLET TUBE (13).
INSTALL LARGER DIAMETER END OF OIL OUTLET TUBE (13) IN OUTLET NECK OF OIL PUMP
ASSEMBLY (1) UNTIL OIL OUTLET TUBE (13) BOTTOMS IN BORE.
INSTALL SMALLER DIAMETER END OF OIL OUTLET TUBE (13) IN OIL OUTLET TUBE ELBOW
(14) UNTIL OIL OUTLET TUBE (13) BOTTOMS IN BORE.
NOTE
Make sure all old gasket material has been removed from mating surfaces of oil
outlet tube elbow and cylinder block.
INSTALL NEW GASKET (15) AND OIL OUTLET TUBE ELBOW ASSEMBLY (14) ON CYLINDER
BLOCK (2). INSTALL TWO BOLTS (16) AND TIGHTEN TO 22-24 LB-FT (30-38 N.m).
3-213
