TM 9-2320-363-34-1
19.
20.
21.
22.
INSTALL SHORTER END OF OIL PUMP DRIVEN GEAR AND SHAFT ASSEMBLY (16) IN LEFT SIDE
BUSHING IN OIL PUMP BODY (1) AS VIEWED FROM TOP REAR.
LUBRICATE BUSHINGS (3) IN OIL PUMP COVER (7) WITH LIGHT ENGINE LUBRICATING OIL.
INSTALL OIL PUMP COVER (7) ON OIL PUMP BODY (1).
INSTALL TWO SHORTER BOLTS (17) IN UPPER TWO BOLTS HOLES AND TWO LONGER BOLTS
(18) IN LOWER TWO BOLT HOLES IN OIL PUMP COVER (7). TIGHTEN BOLTS TO 22-28 LB-FT
(30-38 N.m) IN CRISSCROSS PATTERN.
23. MOUNT DIAL INDICATOR ON MACHINED SURFACE
LEG OR OTHER SUITABLE CLAMPING SURFACE.
OF RIGHT SIDE OIL PUMP BODY MOUNTING
24. MEASURE GEAR FACE RUNOUT JUST INBOARD OF OIL PUMP DRIVE GEAR TEETH (19) WHILE
ROTATING GEAR BY HAND. GEAR FACE RUNOUT MUST NOT EXCEED 0.003 IN. (0.007 mm). IF
GEAR FACE RUNOUT EXCEEDS 0.003 IN. (0.007 mm), REPLACE GEAR.
3-211