TM 9-2320-363-34-1
7.
PLACE OIL PUMP COVER (7), PUMP BODY SIDE DOWN, ON PRESS SUPPORT. APPLY THIN
FILM OF LUBRIPLATE 105 TO BUSHING BORES (8).
8.
POSITION BUSHINGS (9) LOOSELY OVER PUMP COVER BUSHING BORES (8).
9.
ROTATE BUSHINGS (9) SO SPLIT LINES (10) ARE ALINED IN PUMP COVER BUSHING BORES
AS SHOWN.
NOTE
Bushings must be installed to specified depth below finished surface of pump
cover.
10. PRESS BUSHINGS (9) IN PUMP COVER BUSHING BORES (8) 0.011-0.031 IN. (0.3-0.8 mm) BELOW
FINISHED SURFACE OF OIL PUMP COVER (7).
3-207
