TM 9-2320-363-34-1
1.
INSTALL NEW SEAL (8) ON SPACER (6) AND
2.
INSTALL NEW SEAL (7) ON SPACER (6).
3.
INSTALL SOLENOID (5) ON TOP OF SEAL (7)
INSTALL ON INJECTOR BODY (4).
AND SPACER (6).
4.
ELECTRO-ETCH LAST FOUR NUMBERS OF INJECTOR ASSEMBLY PART NUMBER ON OUTSIDE
FACE OF NEW LOAD PLATE (2).
5.
INSTALL NEW FOLLOWER RETAINER (3), LOAD PLATE (2), AND FOUR NEW SCREWS (1).
6.
TIGHTEN FOUR SCREWS TO 5 LB-IN. (0.6 N.m) IN SEQUENCE SHOWN.
7.
TIGHTEN FOUR SCREWS AGAIN TO 20 LB-IN. (2.26 N.m) USING SAME SEQUENCE.
NOTE
Follow-on Maintenance:
Install injector (page 3-108).
3-115