TM 9-2320-302-34
0010 00-17
POWER PACK REPLACEMENT - CONTINUED
0010 00
POWER PACK ASSEMBLY - CONTINUED
6.
Tighten remaining screws (178) to 40 lb-ft (54 Nm).
7.
Remove plug (186) and rotate torque convertor to align holes in flex plate with holes in torque convertor.
WARNING
Do not place finger in hole of engine flywheel housing while engine is being barred over. To do so could
result in serious injury to personnel.
CAUTION
•
Step 8 must be followed for barring over engine. Any other method could cause damage to equipment.
•
If bolts are dropped in engine flywheel housing, retrieve immediately. Failure to do so could result in
damage to equipment.
8.
Have assistant bar engine (156) over using accessory drive (175). Locate and align holes and install bolt (176) through
hole in engine flywheel housing (155). Repeat until 12 bolts have been installed hand-tight.
9.
Tighten 12 bolts (176) to 96-115 lb-ft (130-156 Nm).
180
177
155
186
178, 179
156
176
175
155
