TM 9-2320-302-34
0010 00-16
POWER PACK REPLACEMENT - CONTINUED
0010 00
POWER PACK SEPARATION - CONTINUED
CAUTION
To avoid binding during removal, check frequently to ensure proper alignment between engine and transmis-
sion. Failure to do so could result in damage to components.
3.
Raise and adjust height of transmission lift to maintain support of transmission (177).
4.
Repeat step 3 until transmission (177) can be separated from engine (156).
NOTE
If engine is to be replaced, perform steps 5 and 6 after repositioning engine on suitable stands.
5.
Remove two screws (181), washers (182), two screws (183), and right engine leg (184).
6.
Repeat step 5 for left engine leg (185).
POWER PACK ASSEMBLY
1.
Install right engine leg (184) with two screws (183), washers (182), and screws (181).
2.
Repeat step 1 for installation of left engine leg (185).
CAUTION
Transmission must be seated squarely against engine flywheel housing to prevent damage to equipment.
3.
Support transmission (177) using transmission lift. Position transmission squarely against engine flywheel housing
(155).
4.
Install two brackets (180), 12 new lock washers (179), and screws (178) in transmission (177). Tighten screws hand-
tight.
5.
Tighten four screws (178) 90 degrees apart to 40 lb-ft (54 Nm).
186
182
181
184
183
183
185
182
181
