TM 9-2320-302-34
0099 00-4
FRONT SPRING REPLACEMENT - CONTINUED
0099 00
INSTALLATION - CONTINUED
2.
Install pin (33) and two washers (32) in spring (3).
3.
Using floor jack, raise front axle (2) so that front end of spring (3) is positioned in front spring hanger (31). Install two
saddle caps (30), four washers (29), screws (28), and grease fitting (27). Tighten screws to 50 lb-ft (68 Nm).
4.
Install pin (25), four shims (24), two wear plates (23), shackles (22), washers (21), screws (20), washers (19), nuts (18),
and grease fitting (17) in rear spring hanger (26).
5.
Position spring (3) in two shackles (22) and install four shims (15), two wear plates (14), and pin (16).
6.
Align grooves in pin (16) with holes in two shackles (22) and check end play. End play should be no more than 1/32 in
(0.8 mm). Add shims (15) to correct end play. If possible, add same number of shims on each side of pin.
7.
Install two washers (13), screws (12), washers (11), nuts (10), and grease fitting (9).
CAUTION
Incorrect installation of axle stop will cause damage to axle and frame during use.
8.
Install axle stop (7) in position noted during removal. Install two U-bolts (6), four washers (5), and nuts (4). Tighten nuts
to 380-460 lb-ft (515-624 Nm).
9.
If removed, install stop cushion (8) in axle stop (7) (TM 9-2320-302-20).
2
37
36
35
34
3
33
27
32
32
30
28
29
30
31
