TM 9-2320-302-34
0090 00-3
STEERING COLUMN REPLACEMENT - CONTINUED
0090 00
REMOVAL - CONTINUED
NOTE
Heat base of yoke, if necessary, for ease in removal.
5.
Remove nut (4) and bolt (5) from steering column yoke (6) and separate yoke from steering column (3). Discard nut and
bolt.
6.
Remove two screws (7) and spacer block (8) from steering column (3) and steering column bracket (9).
7.
Loosen two screws (10) and remove steering column (3) from vehicle.
INSTALLATION
1.
Position steering column (3) on steering column bracket (9) and install two screws (7). Tighten screws to 180 lb-in (20
Nm).
2.
Tighten two screws (10) to 180 lb-in (20 Nm).
3.
Using wire brush and liquid detergent, clean serrations of steering column yoke (6) and steering column shaft (11).
4.
Apply adhesive primer to steering column shaft (11). Let dry for five minutes.
5.
Apply sealing compound to inside of steering column yoke (6) and install yoke to steering column shaft (11).
6.
Install new bolt (5) and nut (4). Tighten nut to 37 lb-ft (50 Nm).
7.
Apply sealing compound to exposed threads of screw.
8.
Connect horn wire to steering column (3).
9.
Connect connector to turn signal switch (2).
10.
Install turn signal switch (2) to steering column (3) and tighten clamp screw.
11.
Install trailer brake control valve (1) and tighten clamp.
12.
Install steering column covers (TM 9-2320-302-20).
13.
Install steering wheel (TM 9-2320-302-20).
14.
Test drive vehicle (TM 9-2320-302-10) and check steering.
END OF WORK PACKAGE
