TM 9-2320-302-20
0035 00-2
AUTOMATIC ETHER STARTING AID MAINTENANCE - CONTINUED
0035 00
FUEL CYLINDER REMOVAL - CONTINUED
1.
Loosen clamp (1) and unscrew fuel cylinder (2) from valve (3).
2.
Remove gasket (4) from valve (3). Discard gasket.
AUTOMATIC STARTING AID REMOVAL
1.
Disconnect main harness connector (5) from ether control relay harness connector (6).
2.
Disconnect main harness connector (7) from harness connector (8).
3.
Disconnect ether tube (9) from fitting (10).
NOTE
Fitting has left-hand threads. Turn right to remove fitting.
4.
Remove fitting (10) from valve (3).
5.
Disconnect ether tube (9) from atomizer (11) on intake manifold.
CAUTION
Note orientation of atomizer nozzle prior to removal. Orientation mark must be positioned so that orifice is
facing against air flow of intake manifold. This will ensure proper dispersal of ether. Failure to install atom-
izer nozzle with orifice orientated properly may cause damage to engine from improper dispersal of ether.
6.
Remove atomizer (11) from intake manifold.
7.
Remove four bolts (12), washers (13), nuts (14), and either control relay (15) from ether control relay bracket (16).
9
11
19
20
12
26
27
16
13
14
15
6
7
5
25
24
22
23
1
17
3
19
18
21
10
9
8
2
4
