TM 5-2330-325-13&P
0043
MALE CONNECTOR REPAIR
1.
Position shell (Figure 4, Item 5) from contact (Figure 4, Item 1) and remove washer (Figure 4, Item 4) from
insulation (Figure 4, Item 3).
2.
Remove wire contact (Figure 4, Item 1) from wire lead (Figure 4, Item 2). Discard contact (Figure 4, Item 1).
CAUTION
Remove only enough insulation to fill cavity on new terminal. Failure to comply may result
in damage to, or destruction of, equipment or mission.
3.
Remove insulation (Figure 4, Item 3) from wire lead (Figure 4, Item 2).
4.
Using crimp tool, install new contact (Figure 4, Item 1) on wire lead (Figure 4, Item 2).
5.
Install washer (Figure 4, Item 4) on insulation (Figure 4, Item 3) and position shell (Figure 4, Item 5) over
contact (Figure 4, Item 1).
6.
Connect intervehicular connector and check for proper operation (WP 0005).
1
2
3
4
5
466_0127
Figure 4.
Male Connector Repair.
END OF TASK