TM 5-2330-325-13&P
0043
IDENTIFICATION BAND REPLACEMENT
1.
Remove identification band (Figure 2, Item 2) from wire lead (Figure 2, Item 1). Discard identification band
(Figure 2, Item 2).
2.
Using electrical etcher, mark new identification tag (Figure 2, Item 2).
3.
Install new identification band (Figure 2, Item 2) on wire lead (Figure 2, Item 1).
4.
Secure new identification band (Figure 2, Item 2) to wire lead (Figure 2, Item 1) by bending tab
(Figure 2, Item 3).
2
1
466_0125
3
Figure 2.
Identification Band Replacement.
END OF TASK
TERMINAL REPLACEMENT
1.
Remove terminal (Figure 3, Item 1) from wire lead (Figure 3, Item 2). Discard terminal (Figure 3, Item 1).
CAUTION
Remove only enough insulation to fill cavity on new terminal. Failure to comply may result
in damage to, or destruction of, equipment or mission.
2.
Remove insulation (Figure 3, Item 3) from wire lead (Figure 3, Item 2).
3.
Using crimp tool, install new terminal (Figure 3, Item 1) on wire lead (Figure 3, Item 2).
4.
Connect intervehicular connector and check for proper operation (WP 0005).
3
1
2
466_0126
Figure 3.
Terminal Replacement.
END OF TASK