M1070 HET ARMOR KIT
II113400
Rev. D
8. Connect heater core coolant hoses (disconnected in Teardown, Chapter 2) to firewall elbows per
TM 9-2320-360-2.
9. Re-install power steering reservoir and brackets (tied out of the way in Teardown, Chapter 2) onto firewall
per the following procedure. (See Figure 4-3)
a. Temporarily remove the eight 3/8-16 GR8 locknuts and USS flat washers securing power steering
brackets to firewall panel.
b. Assemble three 3/8-inch USS flat washers (1) onto each of the eight studs protruding from the firewall
and power-steering bracket.
c. Install power steering reservoir assembly onto studs and then secure using eight 3/8-inch USS flat
washers, and eight 3/8-inch-16 GR8 locknuts, removed from step 9.a, as per TM 9-2320-360-2.
Step 9b.
Install 3 flat washers (1) onto each of the 8 studs from steering
reservoir bracket. (Washers used for required stand-off.)
Figure 4-3. Re-installation of Power Steering Reservoir Assembly
JUNE 2005