M1070 HET ARMOR KIT
II113400
Rev. D
5. Install windshield armor panel as follows (see Figure 3-6):
a. Tape back the clearance light wires in the upper corner on the driver's side.
b. Using appropriate lifting device, equipment, and personnel, lift windshield armor panel assembly into
position.
CAUTION
This operation requires teamwork and communication in order to properly align
the slots and holes in the windshield armor panel onto the studs of the windshield
brackets. DO NOT hammer on the studs, and do not use power impact wrenches
to install the locknuts; damage to the studs may occur. Use light oil and hand
tools to run the nuts down the studs.
c. Once windshield armor panel is properly located on the windshield bracket studs, secure windshield
armor panel with 30 locknuts (1) and flat washers (2). Torque locknuts to 7 lb-ft.
1
d. Remove lift hooks and save attachment hardware.
2
Remove lift hooks
after installation.
Figure 3-6. Windshield Armor Panel Installation.
JUNE 2005