TB 9-2320-360-13&P-2
DOOR ASSEMBLY REPLACEMENT - CONTINUED
0015 00
CLEANING AND INSPECTION
Clean and inspect all parts IAW General Maintenance Instructions (WP 0011 00).
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Door assembly weighs 330 lb (150 kg).
1.
Attach lifting device to lifting eyes or door assembly (8).
2.
Using lifting device, align holes in door assembly (8) with holes in hinge (12).
3.
Install 13 bolts (11), washers (10), and new locknuts (9) on door assembly (8). Hand-tighten locknuts.
NOTE
Make sure door closes and does not contact door sill.
4.
Check alignment between door assembly (8) and cab opening. Adjust door assembly as necessary until alignment is cor-
rect.
5.
Tighten 13 locknuts (9) to 35 lb-ft (47 Nm).
6.
Remove lifting device from door assembly (8).
NOTE
Perform step 7 if strap assembly was removed from door frame.
7.
Install strap assembly (3), washer (7), bolt (6), washer
1,2
3
4,5
(5), and new locknut (4) on cab.
8.
Install strap assembly (3), washer (2), and bolt (1) on
door assembly (8).
6,7
8
417-091
0015 00-3
