Freightliner M915 / M916 -
Installation Manual P/N 0257550622-00
Crew Protection Kit
(Doc No.: II113500-1 D)
4. Lift part #007 into position as shown in Figure 7-8. Insert the aft-most bolts (Item 22).
Temporarily use the aft fasteners to hold the deflector in position. Install the center and
forward fasteners next with the 113513-3 and 113513-1 spacers respectively (do not
tighten the bolts until all fasteners are in place). Apply thread-locking compound to the
bolts. Install the hardware in the following order:
Star Washer
Flat Washer
Insert bolt from beneath through assembled parts
Flat Washer
Nut.
5. Tighten bolts to a 122-Nm (90 lb-ft) torque.
6. Ensure that the flexible brake lines are not rubbing on the inside lower edge of the wheel
zone deflector (#007). If the lines are rubbing near the Wheel Zone Deflector, it may be
possible to relocate them by loosening the hose end fitting, twisting the lines slightly, and
then re-tightening the hose end fittings.
7. Apply protective hose wrap to the flexible brake lines in the area shown in Figure 7-9.
IMPORTANT
Raise the rear end of part #971 as high as possible before connecting with part
#967. Use the same procedure with #970 and #658 when installing the right hand
wheel housing.