TB 9-2320-279-13&P-4
0074
ROTATION
DIRECTION
3
1
2
4
Figure 2.
CAUTION
Do not allow cable end to extend past edge of winch drum. Failure to comply may result in
damage to equipment.
NOTE
As one screw is tightened, the other will loosen slightly until clamp block is seated around
cable.
2. Place clamp block (2) over cable (4) and install two screws (1). Tighten screws alternately until both are tight.
NOTE
If new cable was installed, proceed to Step (3) and New cable Break-In section, otherwise
proceed to Follow-On Maintenance.
3. Break-in new cable.
END OF TASK