TB 9-2320-279-13&P-4
0033
HEAVY-DUTY WINCH
4
3
2
1
REMOTE CONTROL
UNIT
REMOTE CONTROL
CABLE CONNECTOR
E
A
D
REMOTE CONTROLLER
B
C
ASSEMBLY WIRING
HARNESS
FOUR TERMINAL
CONNECTOR
Figure 12.
5.
Connect negative (-) probe of multimeter to wire 1854 at four terminal connector, terminal 1.
6.
Multimeter should display a reading less than 200 ohms. Note reading.
7.
Connect positive (+) probe of multimeter to wire 1681 at remote control cable connector, terminal A.
8.
Connect negative (-) probe of multimeter to wire 1681 at four terminal connector, terminal 4.
9.
Multimeter should display a reading less than 200 ohms. Note reading.
10.
Connect positive (+) probe of multimeter to wire 1682 at remote control cable connector, terminal B.
11.
Connect negative (-) probe of multimeter to wire 1682 at four terminal connector, terminal 3.
12.
Multimeter should display a reading less than 200 ohms. Note reading.
13.
Connect positive (+) probe of multimeter to wire 1435 at remote control cable connector, terminal E.
14.
Connect negative (-) probe of multimeter to wire 1435 at four terminal connector, terminal 2.
15.
Multimeter should display a reading less than 200 ohms. Note reading.
CONDITION/INDICATION
Is continuity measured on heavy-duty winch remote control unit harness wires 1854, 1861, 1862, and 1435?
DECISION
No - Repair damaged wire(s) or replace heavy-duty winch remote control unit harness. (WP 0047)Test 20 - Does
winch operate with remote control?
Yes - Test 13 - Is continuity measured on heavy-duty winch remote control unit blue wire?