TB 2300-420-20-1
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (FRONT ONLY OF TWO-PIECE) - Continued
3. When shift lever end of control assembly (A) is visible at bulkhead slip retainer (C) on control assembly.
4. Hold retainer (C) in place while feeding control assembly (A) forward.
5. Route control assembly (A) along right side of
hull behind periscope box and ammunition rack
and down into driver's station to base of
transmission shift control.
NOTE
Make sure control assembly is
secured to hull wall with clamp (D)
located on metal casing 1 inch below
disconnect nut (G).
6. Mechanic at rear of tank, install clamp (D) over
metal casing of control assembly (A) 1 inch from
threads. Using 7/16 inch combination wrench,
secure control to hull with screw (E) and
lockwasher (F).
TA173278
40