TB 2300-420-20-1
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (FRONT ONLY OF TWO-PIECE)-Continued
CLEANING AND INSPECTION:
Inspect all mounting hardware for cracks in brackets, worn pivot pins, and damaged threads on screws and nuts. Replace
any damaged parts. Clean parts, using dry cleaning solvent, if necessary.
INSTALLATION:
1. Go to engine compartment. Using safety wire extending behind fuel tank, wrap threads of shift lever end of new
control assembly several times. Make sure that safety wire is tight around control assembly (A).
NOTE
Wrap free end (disconnect point) of new control assembly (A) with tape to protect inner shaft from dirt.
2. With one person inside turret pulling safety wire extending from bulkhead, second person carefully thread control
assembly (A) through tube located behind fuel tank (B).
TA173277
39