TB 9-2300-420-20-1
PARKING BRAKE CONTROL ASSEMBLY REPLACEMENT (ONE-PIECE)- Continued
CLEANING AND INSPECTION:
Inspect all mounting hardware for cracks in brackets, worn pivot pins, and damaged threads on screws and nuts. Replace
any damaged parts. Clean parts, using dry cleaning solvent, if necessary.
INSTALLATION:
NOTE
Once new control (A) has been guided into the tank, mechanic in driver's compartment should
position himself in turret, near the bulkhead.
1. Mechanic at rear of tank, grasp control (B) with both hands and slowly pull old control (B) out rear of tank while
mechanic in driver's compartment feeds in new control assembly (A).
2. When adapter (C) is near bulkhead as shown, disconnect adapter from both control assemblies (A and B).
TA173266
28