TM 9-2320-363-34-2
1.
LUBRICATE NEW CAMSHAFT THRUST PLATE SEAL RING (1) WITH CLEAN ENGINE
LUBRICATING OIL. INSTALL SEAL RING (1) ON THRUST PLATE (2).
I
W A R N I N G
I
Adhesives, solvents, and sealing compounds can burn easily, can give off
harmful vapors, and are harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in well-ventilated area. If adhesive,
solvent, or sealing compound gets on skin or clothing, wash immediately with
soap and water.
I
C A U T I O N
I
I
Spray adhesive on diamond seal only, not on face of thrust pIate. Failure to
do so could result in damage to equipment.
I
2.
SPRAY THIN COAT OF ADHESIVE ON ONE SIDE OF NEW DIAMOND SHAPED SEAL (3). INSTALL
SEAL (3) ON ENGINE SIDE OF THRUST PLATE (2).
3.
INSTALL CAMSHAFT DRIVE GEAR ASSEMBLY (4) IN GEAR HOUSING OPENING (5).
4.
MAKE SURE DIMPLE (6) ON REAR FACE OF THRUST PLATE IS POSITIONED AT 12 O’CLOCK. IF
NECESSARY, TAP CAMSHAFT DRIVE GEAR HUB TOWARD ENGINE WITH FIBER OR PLASTIC
MALLET UNTIL REAR FACE OF THRUST PLATE IS 1/4 IN. (6.35 mm) (7) FROM FACE OF
CYLINDER HEAD (8). MAKE SURE THRUST PLATE IS NOT TILTED IN BORE.
NOTE
Follow-on Maintenance:
Install camshaft and bearings (page 3-162).
Install bull idler gear (page 12-93).
12-67
