TM 9-2320-363-34-2
I
NOTE
Minimum force of 4,500 lb (20 kN) must be obtained when pressing gear on hub.
When pressing, only apply force to inner hub of gear.
1.
LUBRICATE CONTACT SURFACES OF DRIVE GEAR HUB(l) AND CAMSHAFT THRUST PLATE (2)
WITH CLEAN ENGINE LUBRICATING OIL.
2.
INSTALL DRIVE GEAR HUB (1) ON CAMSHAFT THRUST PLATE (2).
3.
INSTALL NEW KEY (3) IN KEYWAY OF DRIVE GEAR HUB (1).
4.
APPLY THIN FILM OF LUBRIPLATE 105 (OR EQUIVALENT) TO BORE OF CAMSHAFT DRIVE
GEAR (4).
5.
SUPPORT DRIVE GEAR HUB FROM ENGINE SIDE. ALINE KEYWAY (5) OF CAMSHAFT DRIVE
GEAR WITH KEY (3) IN DRIVE GEAR HUB (l). PRESS CAMSHAFT DRIVE GEAR (4) ONTO DRIVE
GEAR HUB (1) UNTIL GEAR IS FIRMLY SEATED AGAINST HUB SHOULDER.
12-65
