page 2-33
TM 9-2320-363-34-2
Use general cleaning methods to clean all parts (page 2-30).
1.
Check gear
straightedge
housing by placing straightedge across bore. If you can slip 0.005 in. feeler gage under
in cut-out area, replace gear housing.
2.
Check gears and drive shaft for scoring, grooving,
3.
Check thrust plates for scoring, pitting, or erosion.
or burring of teeth or splines. Replace if damaged.
Replace if damaged.
C A U T I O N
Replace all seals during assembly. Failure to do so could result in fluid leaks
and/or damage to pump.
1.
INSTALL NEW SEAL (1), RETAINER (2), SPACER (3), AND SNAP RING (4) IN COVER (5).
23-15
