TM 9-2320-363-34-2
NOTE
Perform steps 2 and 3 on M916A1 only.
2.
USING SUITABLE PRESS, INSTALLING ADAPTER P/N 204266, AND REMOVING ADAPTER P/N
38095, PRESS NEW CENTER BUSHING ASSEMBLY (1) IN UNTIL INSTALLING ADAPTER IS FLUSH
WITH EQUALIZING BEAM (2).
3.
INSTALL TWO NEW SEALS (3) AND GREASE FITTING (4).
NOTE
Perform step 4 on M915A2 only.
4.
USING SUITABLE PRESS, INSTALLING ADAPTER P/N 302026, AND PRESS ADAPTER P/N 206457,
INSTALL NEW CENTER BUSHING (5) IN EQUALIZING BEAM (2).
5.
USING SUITABLE PRESS, INSTALLING ADAPTER CLAMP P/N 42052, PLATE CLAMP P/N 206459,
AND PRESS ADAPTER P/N 206457, CLAMP INSTALLING ADAPTER CLAMP TO NEW BUSHING (6).
WITH PLATE CLAMP AND PRESS ADAPTER ASSEMBLED AS SHOWN, PRESS BUSHING (6) UNTIL
COMPLETELY INSTALLED AND CENTERED IN EQUALIZING BEAM (2).
6.
REPEAT STEP 4 FOR OTHER BUSHING (6).
NOTE
Perform step 7 on M916A2,
M917A1, and M917A1 w/MCS only.
7.
USING SUITABLE PRESS AND PIN
ADAPTER SET P/N 1747, INSTALL TWO
NEW BAR PIN BUSHINGS (7) IN
EQUALIZING BEAM (2).
NOTE
Follow-on Maintenance:
Install equalizing beam (page 9-22 or 9-28).
Change 1 21-5/(21-6 Blank)
