TM 9-2320-363-34-2
Section II. HOOD SMC REPAIR
This section illustrates and describes procedures for inspection and repair of the hood SMC.
HOOD SMC REPAIR
This task covers:
a. Inspection b. Repair
Tools and Special Equipment:
Shop Equipment, SC 4910-95-CL-A31
Tool Kit, SC 5180-90-CL-N05
Materials/Parts:
Glass, Reinforced
Plastic
Kit, Lamination
Repair
Appendix B, Item 30
General Safety Instructions:
W A R N I N G
A d h e s i v e s ,
solvents, and
sealing compounds can burn
easily, can give off harmful
vapors, and are harmful to
skin and clothing. To avoid
injury or death, keep away
from open fire and use in
w e l l - v e n t i l a t ed
area.
if
adhesive, solvent, or sealing
compound gets on skin or
clothing, wash immediately
with soap and water.
W e a r g o g g l e s a n d a i r
p u r i f y i n g r e s p i r a t o r w h en
cutting, grinding, or sanding
during fiberglass repairs.
Ground dust and particles
could cause temporary or
permanent damage to eyes,
and if inhaled, could cause
respiratory irritation.
To prevent injury, compressed
air will not exceed 30 psi (207
kPa). Use only with effective
chip guarding and personal
protective equipment, goggles,
shield, and gloves.
22-4
