6.
7.
TM 9-2320-363-34-2
NOTE
To perform step 6, refer to item II.
USING TAPE MEASURE, MEASURE DISTANCE BETWEEN THREE SETS OF POINTS (1 AND 2),
(3 AND 4), AND (5 AND 6). IF DISTANCE IS NOT 33.5 IN. (85.1 cm), FRAME IS BENT.
NOTE
To perform step 7, refer to item III.
MEASURE AND NOTE DISTANCE BETWEEN POINTS (1 AND 6) AND (2 AND 5). DISTANCES
SHOULD BE EQUAL ±0.125 IN. (±3.2 mm). IF NOT EQUAL, FRAME IS OUT OF ALINEMENT.
1.
INSPECT FRAME RAILS FOR CRACKS, BENDS, OR MISALINEMENT.
2.
INSPECT ALL CROSSMEMBERS FOR CRACKS OR OTHER DAMAGE.
3.
INSPECT ALL BOLTED BRACKETS AND SUPPORTS FOR CRACKS OR OTHER DAMAGE.
1.
IF FRAME RAILS, CROSSMEMBERS, BRACKETS, OR SUPPORTS ARE DAMAGED,
ACCORDANCE WITH TB 9-2300-247-40.
REPAIR IN
2.
IF BRACKETS OR SUPPORTS ARE DAMAGED AND CAN BE REPAIRED BY WELDING, REFER TO
TM 9-237 FOR WELDING PROCEDURES.
NOTE
Follow-on Maintenance:
Install front bumper (TM 9-2320-363-20).
Install trailer connector cover (M916A1) (TM 9-2320-363-20).
20-43/(20-44 Blank)
