TM 9-2320-363-34-2
Section VIII. RAMP REPLACEMENT
OVERVIEW
This section illustrates and describes procedures for removal, cleaning, inspection, and installation of the
ramp.
RAMP REPLACEMENT
This task covers:
a. Removal b. Cleaning c. Inspection d. Installation
INITIAL SETUP
Tools and Special Equipment:
Tool Kit, SC 5180-90-CL-N05
REMOVAL
1.
2.
3.
NOTE
Procedure is the same for all vehicles. M916A1 and M916A2 are shown.
REMOVE THREE NUTS (1), THREE WASHERS (2), THREE SCREWS (3), AND THREE WASHERS
(4).
REMOVE THREE NUTS (5), THREE WASHERS (6), THREE SCREWS (7), AND THREE WASHERS
(8) FROM LEFT RAMP (9).
REPEAT STEPS 1 AND 2 FOR RIGHT RAMP (10).
CLEANING
Use general cleaning methods to clean all parts (page 2-30).
INSPECTION
Inspect all parts for wear or damage.
20-38 Change 1
