TM 9-2320-363-34-2
1.
2.
3.
INSTALL NOTCHED UPPER MAIN BEARING SHELL (1) IN MAIN BEARING SADDLE NO. 6 WITH
TANG OF MAIN BEARING SHELL (1) IN NOTCH AT PARTING LINE OF MAIN BEARING SADDLE
NO. 6.
COAT BACKS OF TWO THRUST WASHERS (2), ON SIDE WITHOUT OIL GROOVES, WITH THIN
FILM OF LUBRICATING OIL. INSTALL TWO THRUST WASHERS (2) IN COUNTERBORE ON EACH
SIDE OF MAIN BEARING SADDLE NO. 6. ENGAGE TANGS ON ENDS OF TWO THRUST
WASHERS (2) WITH NOTCHES ON ENDS OF NOTCHED UPPER MAIN BEARING SHELL (1).
INSTALL REMAINING UPPER MAIN BEARING SHELLS (3) IN MAIN BEARING SADDLES OF
CYLINDER BLOCK (4) WITH TANGS ON UPPER MAIN BEARING SHELLS (1) IN NOTCHES AT
PARTING LINE OF MAIN BEARING SADDLES.
12-53
