TM 9-2320-363-34-2
16.
17.
18.
19.
20.
21.
22.
23.
24.
COAT SIX CAPSCREWS (22) WITH LOCTITE 242 AND INSTALL SPACER (23), BEARING SUPPORT
(9), AND SIX CAPSCREWS (22). TIGHTEN CAPSCREWS TO 42 LB-FT (57 N.m).
INSTALL LOCK WASHER (24) AND LOCK NUT (25). USING HAMMER AND PUNCH, BEND UP ONE
OR TWO TANGS ON LOCK WASHER (24).
TURN TRANSFER CASE REAR HALF (5) OVER AND INSTALL SHIMS (26), BEARING CAP (27), SIX
NEW LOCK WASHERS (28), AND SIX CAPSCREWS (29). TIGHTEN CAPSCREWS TO 60 LB-FT
(81 N.m).
TURN TRANSFER CASE REAR HALF (5) OVER.
NOTE
Rotate rear output shaft back and forth to seat rollers before checking end play.
MOUNT DIAL INDICATOR (30) ON MACHINED SURFACE OF BEARING SUPPORT (9).
USING PRY BAR AND FULCRUM, CHECK THAT END PLAY IS 0.003-0.006 IN. (0.08-0.15 mm). ADD
OR REMOVE SHIMS (26) TO ACHIEVE CORRECT END PLAY.
REMOVE DIAL INDICATOR (30), SIX CAPSCREWS (29), SIX NEW LOCK WASHERS (28), AND END
CAP (27).
APPLY LIGHT BEAD OF ADHESIVE TO INSIDE OF END CAP (27) FLANGE AND INSTALL END
CAP (27) AS IN STEP 18.
IF REMOVED, INSTALL TWO NEW PINS (31).
15-15