TM 9-2320-363-34-2
3.
4.
5.
6.
7.
8.
9.
NOTE
Bearing surface measurement will be used on page 14-139 to find output shaft
bushing clearance.
MEASURE AND NOTE DIAMETER OF BEARING SURFACE (1) OF MAIN SHAFT (2).
MEASURE DIAMETER OF FRONT CARRIER BEARING SURFACE (3).
MEASURE INSIDE DIAMETER OF BUSHING (4).
IF BUSHING (4) TO FRONT CARRIER BEARING SURFACE (3) CLEARANCE IS GREATER
0.0072 IN. (0.18 mm), REPLACE BUSHING (4).
THAN
MEASURE DIAMETER OF BEARING SURFACE (5) ON MAIN SHAFT.
MEASURE INSIDE DIAMETER OF TWO BUSHINGS (6 AND 7) IN SUN GEAR SHAFT (8).
IF CLEARANCE BETWEEN BUSHINGS (6 AND 7) AND BEARING SURFACE (5) IS MORE THAN
0.0064 IN. (0.16 mm), REPLACE BUSHINGS (6 AND 7).
Use general repair methods to repair damaged parts (page 2-33).
14-123
