TM 9-2320-363-34-2
19.
20.
21.
22.
23.
24.
CHECK END PLAY BETWEEN PINION GEARS (23, 24, AND 25) AND CARRIERS (1, 5, AND 20).
END PLAY MUST BE BETWEEN 0.008-0.31 IN (0.203-0.787 mm). IF END PLAY IS OUTSIDE THESE
LIMITS, DO STEPS 20 THRU 25 TO REPLACE ALL PINION GEARS IN THAT ASSEMBLY.
NOTE
Steps 20 thru 25 are required only if end play of pinion gears is outside limits.
DRILL AWAY STAKED REAR ENDS OF FRONT CARRIER ASSEMBLY (1) PINION PINS (26) USING
15/1 6-IN. (23.8-mm) BIT.
DRILL AWAY STAKED FRONT ENDS OF CENTER CARRIER ASSEMBLY (5) PINION PINS (27)
USING 15/16-lN. (23.8-mm) BIT.
DRILL AWAY STAKED ENDS OF REAR CARRIER ASSEMBLY (20) PINION PINS (28) USING
1-3/16 IN. (30.2-mm) BIT.
NOTE
Front, center, and rear carrier assemblies are disassembled the same way.
Disassembly of center carrier is shown.
POSITION CENTER CARRIER ASSEMBLY (5) WITH DRILLED ENDS OF PINION PINS (27) UP IN
PRESS.
PRESS FOUR PINION PINS (27) FROM CENTER CARRIER ASSEMBLY (5).
14-121
