TM 9-2320-363-34-2
GEAR UNIT AND MAIN SHAFT REPLACEMENT AND REPAIR (CONT)
25.
26.
REMOVE PINION GEAR (24), ROLLER BEARING (29), TWO STEEL THRUST WASHERS (30), AND
TWO BRONZE THRUST WASHERS (31) FROM CENTER CARRIER ASSEMBLY (5).
REPEAT STEPS 23 THRU 25 FOR EACH OF FOUR PINION GEARS (24).
Use general cleaning methods to clean all parts (page 2-30).
1.
INSPECT ALL PARTS FOR WEAR OR DAMAGE.
NOTE
All planetary gears in a carrier assembly are replaced as a set.
2.
MEASURE THICKNESS OF THRUST WASHERS; THICKNESS MUST BE NO LESS THAN 0.091 IN.
(2.31 mm).
14-122
